IP Passthrough
When this IP Passthrough option is active, after the ethernet WAN
connection is up, the router’s DHCP server will offer the connection’s IP
address to one LAN client. All incoming or outgoing traffic will be routed
without NAT.
Standby State
This option allows you to choose whether to remain the connection
connected or disconnect it when this WAN connection is no longer in the
highest priority and has entered the standby state.
Reply to ICMP
Ping
If No is selected, this option is disabled and the system will not reply to
any ICMP ping echo requests to the WAN IP addresses of this WAN
connection(Default option is “Yes”)
Upload
Bandwidth
This field refers to the maximum upload speed.
This value is referenced when default weight is chosen for outbound
traffic and traffic prioritization. A correct value can result in effective
traffic prioritization and efficient use of upstream bandwidth.
Download
Bandwidth
This field refers to the maximum download speed.
Default weight control for outbound traffic will be adjusted according to
this value.
WAN > Physical Interface Settings
Physical Interface Settings
Port
Speed
This setting specifies port speed and duplex configurations of the WAN port. By
default,
Auto
is selected and the appropriate data speed is automatically
detected by the Pepwave router. In the event of negotiation issues, the port
speed can be manually specified. You can also choose whether or not to
advertise the speed to the peer by selecting the
Advertise Speed
checkbox.
To Next Page
Loading...
