Algorithm
This setting specifies the behavior of the Pepwave router for the custom
rule.
One of the following values can be selected:
Weighted Balance
Persistence
Enforced
Priority
Overflow
Least Used
Lowest Latency
Fastest Response Time
For a full explanation of each Algorithm, please see the following article:
https://forum.peplink.com/t/exactly-how-do-peplinks-load-balancing-
algorithmns-work/805 (https://forum.peplink.com/t/exactly-how-do-
peplinks-load-balancing-algorithmns-work/8059)
Load
Distribution
Weight
This is to define the outbound traffic weight ratio for each WAN
connection..
When No
Connections
are Available
This field allows you to configure the default action when all the selected
Connections are not available.
Drop the Traffic – Traffic will be discarded.
Use Any Available Connections – Traffic will be routed to any available
Connection, even it is not selected in the list.
Fall-through to Next Rule – Traffic will continue to match next
Outbound Policy rule just like this rule is inactive.
Terminate
Sessions on
Connection
Recovery
In the case when the highest priority connection is unavailable, matching
sessions may routed through a lower priority connection or skipped to
next matching rule (Fall-through to Next Rule). By checking this option,
those sessions will be terminated upon connection recovery of any higher
priority connections. Terminated sessions will go through all the rules
again to determine the outgoing connection.
When Source is a MAC address, this option will be disabled automatically.
Default: Disable
To Next Page
Loading...
