perfect pro Rock Solid - TIME AND DATE SETTINGS; ALARM SETTINGS; Setting the alarm time (only possible in standby mode); Switching on;off the alarm (only possible in standby mode)

9 10
TIME AND DATE SETTINGS
1. The displayed clock will automatically synchronize with the time and date of a RDS
 radiostation(ifavailable,pleasesee“RDSstationservice”).
2. To manually set the time and date, turn off the device by pressing the On/Off
button.
3. Press and hold the Tuning knobforabout12seconds,untiltheclockashesinthe
display.
4. Rotate the Tuning knob to adjust the data and then press the Tuning knob to
 conrmeachpartoftherequiredtimeanddate.
5. Selectandconrm“SynclockOn”whenyouwantthetimeanddatetobeupdated
 bytheRDSsignal.Selectandconrm“SynclockOff”whenyouwanttodisablethe
time and date to be updated by the RDS signal and keep your own manually set
time and date.
Note:WhendisconnectingthedevicefromACpowerthetimesettingwillbelostandwill
have to be picked up again from the RDS signal the next time the device is used again
in FM Radio mode. Menu settings and station presets are stored in the internal memory
and are not lost when the device is disconnected from AC power.
ALARM SETTINGS
Thealarmsettingscanonlybechangedwhenthedeviceisoff(instandbymode).Ifno
buttons are pressed for 5 seconds, the device will exit the alarm setup menu and the
settings are cancelled.
Settingthealarmtime(onlypossibleinstandbymode)
1. Press the Menu button once and rotate the Tuning knob until the display shows
“Alarm Set”.
2. Press the Tuning knobtoenterandthehourdigitsashonthedisplay.
3. Rotate the Tuning knob to set alarm hours.
4. Press the Tuning knobtoconrm.Theminutedigitsash.
5. Rotate the Tuning knob to set alarm minute.
6. Press the Tuning knobtoconrm.
7. The display will then show “Alarm Source”. You may choose either “Buzzer” or “FM
Radio”. Rotate Tuning knob to select. If “FM Radio” is selected, the last listened
station will be played when the alarm rings.
8. The display will then show “Alarm Volume”. Rotate the Volume knob to set the
alarm volume.
9. Press Tuning knobtoconrm.
10. Thealarmicon(abellshape)willbeshownonthedisplay,leftnexttothetime.
Switchingon/offthealarm(onlypossibleinstandbymode)
1. To switch the alarm on, press and hold the Info button and the alarm icon (a bell
 shape)willbeshownonthedisplay,leftnexttothetime.
To switch it off, press and hold the Info button again.
2. To turn off the alarm when it buzzes, simply press the On/Off button.
LANGUAGE SETTINGS
You can adjust the language setting by pressing the Menu button and then pressing the
Tuning knob when “Language” is shown on the Display. Next rotate the Tuning knob
to cycle through the choice of languages and press the Tuning knob to select your
language of choice.
GB
GB