perfect pro Workman 2 - Power Supply and Clock Setup; Battery and AC Power Operation; Setting the Radio Clock

POWER SUPPLY
Battery operation
1. Toopenthebatterycompartment,rstturnthebatterycoverxturesanti-clockwise
to loosen and pull down the battery cover.
2. Insert 6 x D size (UM-1) battery with the correct polarity into the compartment.
 Closethebatterycoverandfastenthexturesbyturningclockwise.
3. If the unit is not to be used for any extended period of time, it is recommended that
the batteries to be removed from the radio.
The approximate power level of the batteries is displayed in the LCD display of the radio.
When the power level is very low the indication “Battery Low!” appears and the battery
symbolashesonthedisplay.Thebatteriesshouldthenbereplacedsoontocontinue
normal operation of the radio.
Back up battery
Back up battery is to back up the preset stations and the clock. It is necessary to insert
back up battery (2 x AA size / UM-3) for memory back up even if you use AC power
supply only. Without the back up battery, time and preset station will get lost if you
remove the AC power cord from AC socket or during power failure.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type. Do not expose the batteries to excessive heat such as
sunshine,reorthelike.Batteriesshouldnotbedisposedofbyincinerationandwith
household waste. Disposable batteries should be taken to a suitable recycling centre if
possible.
AC operation
Before plugging the AC power cord into the AC socket, be sure the voltage is correct.
If you have batteries in the radio and using the AC power supply, the batteries will
automatically be disconnect. AC power cord storage is designed to store the cord when
the radio is not in use.
Note: In order to disconnect the unit from the mains completely, the AC plug should be
removed from the mains socket completely.
5 6
GB
GB
SETTING CLOCK
The clock can only be set when the radio is in standby mode. If no buttons are pressed
for 5 seconds, the radio will exit the clock setup and the setting is cancelled.
1. Press and hold the Tuning Control knobfor12secondsuntilthehourdigitsash
on the display.
2. Rotate the Tuning Control knob to set the hour.
3. Press the Tuning Control knob,theminutedigitsash.
4. Rotate the Tuning Control knob to set the minute.
5. Press the Tuning Control knobtoconrm,thedayashesonthedisplay.
6. Rotate the Tuning Control knob to set the current day.
7. Press the Tuning Control knobtoconrm,themonthash.
8. Rotate the Tuning Control knob to set the current month.
9. Press the Tuning Control knobtoconrm,theyearwillthenashonthedisplay.
10. Rotate the Tuning Control knob to set the current year.
11. Press the Tuning Control knobtoconrm,“SYNCLOCKON”ashes.
12. Rotary the Tuning Control knob to select “SYNCLOCK ON” or “SYNCLOCK OFF”.
13. Press the Tuning Control knobtoconrmandnishtheclocksetting.
RDS time synchronization
If “SYNCLOCK ON” is selected, the symbol “ ” will show on the display. Some
RDS stations transmit a time signal. If reception is good you have selected the
“SYNCLOCK ON” option during the time setting, the time will be automatically
updated (“ ”ashesonthedisplay).Timesynchronisationcantakeseveral
minutes. The automatic time setting is always activated when the radio is switched
from standby to FM broadcasting and receives a RDS station.