To Next PageTo Next Page
Need help?Do you have a question about the PERFECTPASS DigitalPro 6.5NG and is the answer not in the manual?
General| Brand | PERFECTPASS |
|---|---|
| Model | DigitalPro 6.5NG |
| Category | Boating Equipment |
| Language | English |
Guides through the system setup procedure for your boat and engine.
Explains how to turn the system ON/OFF, engage, and disengage.
Explains mode selection and accessing settings like Contrast, Name List, System Info.
Details how to use Slalom mode for optimal and consistent pulls.
Explains RPM Adjust, Name/Mode/Crew, and Menu Arrow functions.
Details Speed/SETPOINT, Course Times, and All Buoy Timing (ABT).
Covers Skier Weight, PX (Rope Switch), and KX (Throttle Response).
Changes screen layout for tournament use, emphasizing timing data.
Recalibrates baseline based on recorded times from the last pass.
Explains calibration for speeds below 23 mph and Master Recal.
Manually sets baselines and calibrates speedometer using boat/GPS speed.
Sets total crew weight and uses calculator for summing crewmembers.
Details SSB, RPM Offset, and Wait Time for tournament use.
Details Jump mode requirements, RPM Adjust, and Name/Mode/Crew.
Details SETPOINT, calibration, and Course Times display.
Explains Jump Letter, S2%, S2 RTB, S2 Fine, and New Jumper entry.
Sets RPM Baseline values for official jump speeds.
Instructions for experienced drivers using Jump mode with integrated timing.
Covers Crew Adj, Calculator, CT, x8u, and x8d settings.
Controls boat via speed, explains SETPOINT, Name/Mode/Crew, Menu Arrow.
Calibrates speedometer and adjusts Kd (Pull Firmness) and NN (Filter Factor).
Controls boat via RPM SETPOINT, similar to Wakeboard/Trick modes.
Speed-based mode using paddlewheel, explains SETPOINT, Name/Mode/Crew.
Calibrates speedometer and adjusts KdW (Pull Characteristic) and NN (Filter Factor).
Adjusts speed to match reference and explains Paddlewheel Factor.
System setup for Slalom/Jump timing and sensor placement.
Ensures no other magnets are present in the course to avoid triggering jump timer.
Adjusts screen contrast and manages user names and settings.
Displays general system information like software version and voltage.
Tests magnets for field strength, polarity, and interprets results.
Tests servo motor functions and the rope switch for proper operation.
Mounts servo motor, connects throttle cable, and tests linkage.
Installs module, display, connects power wire and RPM sensor.
Installs Smart Timer sensor and paddle wheel speed sensor.
Ensures manual throttle feels same as before installation; inspect adjustments.
Details paddlewheel installation, tools, and placement for different boat types.
Troubleshoots servo motor binding, linkage issues, and surging.
Addresses surging in neutral and accelerating past set point.
Checks RPM/speed, fuses, display, and performs a system reset.
Explains the All Buoy Timing Method for tournament use.
Requires reading and signing for warranty and use agreement.
Provides contact info for warranty claims and technical support.
