PERFECTPRO ROCKBOX - Aux in Mode; Setting the Clock

AUX IN MODE
A 3.5mm stereo Aux In socket is provided on the side behind the rubber cover, for
connecting an external audio device such as MP3 player or CD player (not included with
this radio).
1. Connect an audio source to the Aux In socket.
2. Press the Source button to select AUX input. Display will show “AUX IN”.
3. Play the external player.
4. Adjust the volume of both the radio and the player for comfortable listening.
5. After use, close the rubber cover to prevent moist or dust from entering into the
sockets and radio.
Notes: Never use the AUX-IN socket in rainy or moist conditions to prevent moist from
entering the radio. Keep the rubber cover closed under these conditions.
The Auto-Power management function will be activated in AUX mode. If there is no
signal from the AUX input jack for a period over 15 minutes, the unit will automatically
switch to standby mode. The operation indicator and the LCD will go off in such case.
Pressing the On/Standby button will wake up the unit.
SETTING THE CLOCK
The clock can only be set when the radio is in standby mode. If no buttons are pressed
for 5 seconds, the radio will exit the clock setup and the setting is cancelled.
1. Press and hold the Time Set knob for 12 seconds until the hour digits ash on the display.
2. Rotate the Time Set knob to set the hour.
3. Press the Time Set knob to conrm, the minute digits ash.
4. Rotate the Time Set knob to set the minute.
5. Press the Time Set knob to conrm, the day ashes on the display.
6. Rotate the Time Set knob to set the current day.
7. Press the Time Set knob to conrm, the month ashes.
8. Rotate the Time Set knob to set the current month.
9. Press the Time Set knob to conrm, the year will then ash on the display.
10. Rotate the Time Set knob to set the current year.
11. Press the Time Set knob to conrm, “SYNCLOCK ON” ashes.
12. Rotary the Time Set knob to select “SYNCLOCK ON” or “SYNCLOCK OFF”.
13. Press the Time Set knob to conrm and nish the clock setting.
RDS time synchronisation
If “SYNCLOCK ON” is selected, the symbol “
” will show on the clock display.
Some RDS stations transmit a time signal. If reception is good and you have
selected the “SYNCLOCK ON” option during the time setting, the time will be
automatically updated (“
” ashes on the display). Time synchronisation can take
several minutes. The automatic time setting is always activated when the radio is
switched from standby to FM broadcasting and receives a RDS station.
12
GB
GB