DAB MODE
Operating the radio – DAB
1. Carefully extend the antenna. Press the On/Off button to switch on the radio.
2. If this is the rst time to switch on, the radio will be in DAB mode.
3. The rst station (in numeric-alpha order 0…9…A…Z) in the list of stations found will
be played. The display will show the station name.
If the radio has been used before, the last used station will be selected.
4. If no signals are detected, “No stations available” will be displayed. It may be
necessary to relocate the radio to a position giving better reception.
You should then carry out an auto scan to nd stations, please refer to the section
“Find new stations - DAB”.
Selecting a station – DAB
1. Press the On/Off button to switch on the radio. The display will show “Now tuning”
for a few seconds.
2. The display shows the name of the radio station currently selected.
3. Rotate the Tuning knob to scroll through the list of available stations.
4. When the desired station name appears on the display, press the Tuning knob
to select the station. The display will show “Now tuning” while the radio nds the
new station.
Note: If after selecting a station the display shows “No stations available”, it may be
necessary to relocate the radio to a position giving better reception.
Secondary services – DAB
1. Certain radio stations have one or more secondary services associated with them.
If a station has a secondary service associated with it, then the secondary service
will appear immediately after the primary service as you turn the Tuning knob.
2. Press the Tuning knob to select the secondary service.
Most of secondary services do not broadcast continually and if the selected service
is not available, the radio will re-tune to the associated primary service.
7
To Next Page
Loading...
