PERFECTPRO ROCKBOX - Using the Radio for the First Time

USING THE RADIO FOR THE FIRST TIME
1. Place the radio on a at surface.
2. Carefully extend the antenna located on the top of the radio. Adjust the antenna so
it is vertically extending above the radio.
3. Plugging the AC power cord into the AC socket. The radio will start up and the
display will show “WELCOME TO DIGITAL RADIO” for a few seconds. Then the
radio will automatically perform an auto scan of the Band III DAB channels and the
FM band, the display will show “ATS setting”.
4. When the scan is completed, the 10 strongest FM stations will be stored as presets.
The radio will switch to standby with the updated clock and date showing on the
display.
5. If no signals are found, the clock will not be updated. It may be necessary to
relocate the radio to a position giving better reception.
Additional metal telescopic antenna
You can use this as an alternative antenna for your radio in areas or locations where the
radio-signal (FM/DAB/DAB+) is weak to very weak.
ATTENTION; the standard antenna on the radio is exible, this antenna is not
exible.
Installing: Carefully screw off the standard exible antenna. First carefully loosen the
antenna with an open-end-wrench (size 14) – turn counter clockwise.
Carefully screw on the metal telescopic antenna and softly tighten it with an open-end-
wrench key (size 14) – turn clockwise
ATTENTION: do not use too much force when xing the antennas as this can
damage the screw threat of the antennas or make it break off.
6
GB
GB