PERFECTPRO ROCKPRO - Bluetooth Device Pairing

GB
Calling up RDS information
When you are listening to a FM station with RDS system, repeatedly press the
INFO
button
to cycle through the information. This will only function if the reception level is
sufcientandclear.
a. Radio text (RT) Displays the message about the station being listened to as
ticker text.
b. Program type (PTY) Displays the type of station being listened to, e.g. Pop,
Classic, News, etc.
c. Frequency Displays the frequency of the station.
d. Date Displays the date of today.
Scan sensitivity setting
The radio will normally scan all stations from FM broadcasts including the weaker
signals.However,youmaywishtheAuto-scantondonlythosestationswithstrong
enough signals to give good reception.
1. Press the
ON/OFF button
to turn on the radio.
2. Select the FM band by pressing the
SOURCE button
.
3. Press the
MENU button
, rotate the
TUNING/SEEK/SELECT knob
to “Scan
setting”.
4. Press the
TUNING/SEEK/SELECT knob
.
5. Rotate the
TUNING/SEEK/SELECT knob
to select between “All stations” or
“Strong station” (default is All stations).
 The“Strongstation”optionwillallowtheradiotondstrongsignalsonlywhen
scanning.
6. Press the
TUNING/SEEK/SELECT knob
toconrmyoursetting.Thedisplaywill
return to FM menu.
PRESET STATIONS
Storing preset stations
There are 80 memory presets in the radio, 40 for DAB and 40 for FM. Presets are
remembered by the radio in the event of a power failure.
1. Press the
ON/OFF button
to turn on the radio.
2. Press the
SOURCE button
to select the desired waveband.
3. Tune to the required station.
4. Press and hold the required
PRESET button
until the radio shows “Saved to
preset”.
5. Repeat step 3 and 4 for the remaining presets.
6. Stations stored in the preset memories can be over-written by following the above
procedure.
12