Performance Tool M545 - User Manual

AIR POWERED ABRASIVE SPOT BLASTER
Stock Number M545
SPECIFICATIONS:
Nozzle diameter: ......................................5 mm
Hopper capacity: ........................... 17.2 fl. oz. (510 ml)
Maximum air pressure : ................................90 PSI
Air consumption: ............................. 6 CFM @ 90 PSI
Air inlet: ..........................................1/4" NPT
Weight: ......................................14 oz. (0.4 kg)
Specifications are subject to change without notice.
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO SO
MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND
WILL VOID WARRANTY.
Some dust created by sand blasting contains chemicals known to the State of California to cause cancer, birth defects or
other reproductive harm. An example of this type of chemical is lead from lead based paints, Crystalline Silica from bricks
and cement or other masonry, Arsenic and Chromium from chemically treated lumber. Your risk from these exposures varies,
depending on how often you do this type of work. To reduce your exposure: work in a well ventilated area and work with
approved safety equipment, such as dusk masks that are specially designed to lter out microscopic particles.
MANUAL

Performance Tool M545 Specifications

General

Brand	Performance Tool
Model	M545
Category	Airbrushes
Language	English

Summary

Specifications

Nozzle Diameter

Specifies the tool's nozzle diameter.

Hopper Capacity

Indicates the maximum volume the hopper can hold.

Maximum Air Pressure

Defines the highest safe operating air pressure.

Air Consumption

Details the tool's air usage rate.

Air Inlet Size

Specifies the connection size for the air supply.

Tool Weight

States the overall weight of the tool.

Safety Information

General Warnings and Precautions

Critical safety warnings and operational instructions.

Work Area and Personal Safety

Guidelines for a clean work area, child safety, and PPE.

Air Supply and Health Warnings

Safe air supply connection, health advisories, and impairment rules.

Setup and Operation

Air Supply Setup

Instructions for setting up the air supply system.

Tool and Work Area Preparation

Preparing the tool, hopper, and work area.

Abrasive Material Selection

Guidelines for choosing suitable abrasive materials.

Operating the Blaster Gun

Guidance on using the blaster gun, including distance and refilling.

Maintenance and Troubleshooting

Tool Maintenance and Storage

Procedures for pre-use inspection, cleaning, and storage.

Troubleshooting Common Issues

Solutions for common material flow and pattern problems.