3
UNPACKING AND INSPECTION
After opening the carton, unpack your new product and related parts and accessories. Please
inspect it carefully for any damage that may have occurred during transit. Please check it against
the photograph on carton. If any parts are missing, please call customer service at 1-800-426-1262
between 6 a.m. and 5 p.m. Pacific time.
WARNING: DO NOT operate this product if damaged during shipment, handling or misuse.
Do not operate the product until the parts have been replaced or the fault rectified. Failure to do
so may result in serious personal injury or property damage. All damaged parts must be repaired
or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings
are secure before putting this product into service.
If you have any questions, or require assistance with damaged or missing parts, please contact
our customer service department at 1-800-426-1262. Please have the serial number, model
number, and date of purchase available for reference when calling.
WARNING: Always unplug the tool before changing accessories.
WARNING:
The voltage specifications on the rating plate must correspond with the supply voltage.
This impact wrench is equipped with a rocker switch that switches the rotation from clockwise to
counter-clockwise easily, allowing fasteners to be broken loose. Pressing the lower part of the
switch causes the impact wrench to move clockwise. Pressing the upper part of the switch causes
the rotation to reverse, counterclockwise.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accessories
that may be suitable for one tool may become hazardous when used on another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets. If you must use
an extension cord, be sure that the gauge is large enough to carry the amount of current
necessary for your power tool. If not, your tool may experience a loss of power, excessive
voltage drop or overheating.
The smaller the gauge number, the heavier the cord (see table below).
OPERATION