5
1. Repairs must be performed by a qualified expert, using only identical replacement parts.
This will ensure that the safety of the tool is maintained.
2.
Remove the battery from tool and disconnect the charger from the wall outlet before cleaning
.
CLEANING
1. Keep protection devices, air vents and the motor housing as clean (dust free) as possible.
Clean the tool with a clean cloth or clean with compressed air at low pressure.
2. We recommend cleaning the tool directly after each use.
3.
Clean the tool regularly with a damp cloth and a little soap. Do not use any cleaner or
detergent, they can damage the plastic parts of the tool. Ensure that no water enters the tool.
MAINTENANCE
1. The impact wrench will require lubrication after 30 continuous hours or 50 intermittent hours
of use. Contact an approved service center for lubrication services.
Note: UNPLUG WRENCH BEFORE INSPECTING BRUSHES! The brushes should periodically
inspected for repair. Unscrew the plastic caps located on the side of the motor housing to reveal
the spring and brush assembly. Keep brushes clean and freely sliding. Symbols are inscribed
on the brushes, and if it is worn down to the line closest to the spring, replace immediately.
ENVIRONMENTAL PROTECTION
This device uses electronic components, so they should not be deposited with household
garbage! Please help by collaborating to protect resources and the environment. Dispose of
these products through relevant recycling services, if any. For questions on this matter,
please contact your local waste management or a specialized site.
CARE AND MAINTENANCE
• Keep the tool away from children and do not allow tool to be used by people who are not
familiar with the operation of the tool. Tools are dangerous in the hands of inexperienced
operators.
• Make sure the tools moving parts are not aligned or blocked, that it has not broken any parts
or any other condition that may affect the operation of the tool. In case of damage, take the
tool to a repair service before using it again. Many accidents are caused by poorly
maintained tools.
• Use the tool, accessories and blades, etc. according to these instructions, taking into
account the working conditions and the work to be done. The use of the tool for operations
other than those provided can lead to dangerous situations.
USE AND MAINTENANCE OF THE TOOL