1. Remove existing radiator cap.
WARNING: Never remove radiator cap when engine is hot.
2. Identify and install proper adapter and cap on to the radiator or
expansion tank opening.
Note: Be sure the gasket is in place for a proper seal.
3. Fit the funnel snugly into adapter opening. If an angled adapter
or extension is needed, it must be installed prior to installing the
funnel.
4. Slowly pour coolant (see owner’s manual for type of coolant),
into the funnel allowing air to escape. Fill the funnel about 1/3
and start the engine. Idle until engine warms to open thermostat
completely.
WARNING: Excessive RPM can cause fluid to overflow the funnel.
If this happens shut off the engine, wait for the fluid level to drop back
down before restarting engine, wait for the fluid to stabilize.
5. Add coolant until the system is full. If you still have any fluid left
in the funnel shut off the engine. Reach in and squeeze the
upper radiator hose, use caution it may be hot.
6.
With your other hand press the funnel stopper into the hole at the
base of the funnel. Release the hose and it will pull any residual
coolant between the base of the funnel and the radiator cap. This
should provide a spill proof removal of the funnel and cap.
7. Remove the adapters and replace original factory radiator cap.
OPERATION
LIMITED WARRANTY
PERFORMANCE TOOL® extends only the following warranties, and only to original retail purchasers. These warranties give
specific legal rights. Except where prohibited by local law, the law of the State of Washington governs all warranties and all
exclusions and limitations of warranties and remedies. There may be other rights which vary from state to state.
PERFORMANCE TOOL® warrants the product to be free from defects in materials and workmanship under normal use and
service. A defective product may be returned for a free replacement within 90 days from the date of purchase, provided that
product is returned to place of purchase immediately after discovery of defect. After 90 days PERFORMANCE TOOL® will
replace at no charge any parts which our examination shall disclose to be defective and under warranty. These warranties shall
be valid only when a sales receipt showing the date of purchase accompanies the defective product or defective part (s) being
returned. For part (s) after 90 days, please remit your request, postage prepaid to:
PERFORMANCE TOOL, P.O. Box 88259 Tukwila, WA 98138
These warranties exclude blades, bits, punches, dies, bulbs, fuses, hoses, and other consumables which must be replaced
under normal use and service. These warranties shall not apply to any product or part which is used for a purpose for which it is
not designed, or which has been repaired or altered in any way so as to affect adversely its performance or reliability, nor shall
these warranties apply to any product or part which has been subject to misuse, neglect, accident or wear and tear incident to
normal use and service.
PERFORMANCE TOOL® does not authorize any other person to make any warranty or to assume any liability in connection with
its products.
Except for warranties of title and the limited express warranties set forth above, PERFORMANCE TOOL® makes no express or
implied warranties of any kind with respect to its products. In particular, PERFORMANCE TOOL® makes no implied warranty of
merchantability and no implied warranty of fitness for any particular purpose, except that for goods purchased primarily for
personal, family or household use and not for commercial or business use, PERFORMANCE TOOL® makes an implied warranty
of merchantability (and, if otherwise applicable, an implied warranty of fitness for a particular purpose), but only for the particular
qualities or characteristics, and for the duration, expressly warranted above.
The laws on limitation of implied warranties may differ from state to state, so the above limitations may not apply in all cases.
PERFORMANCE TOOL® shall not be liable for consequential, incidental or special damages resulting from or in any manner
related to any product, or to the design, use, or any inability to use the product. The sole and exclusive remedy for a defective
product or part shall be the repair, or replacement thereof as provided above. The laws on limitation of remedies or on
consequential, incidental or special damages may vary from state to state, so the above limitations may not apply in all cases.
© Copyright 2022 WILMAR CORPORATION, P.O. Box 88259 Tukwila, WA 98138
To Previous Page
Loading...
