SELECTING PROPER SPEEDS
Different speeds are required depending
upon the type of operation being
performed. The following chart outlines
those basic speeds:
WARNING: For safety
reasons, the operator must read the
sections of this Owner’s Manual
entitled “GENERAL SAFETY
WARNINGS”, “POWER TOOL
SAFETY”, “SPECIFIC SAFETY
RULES”, “BATTERY AND CHARGER
SAFETY” and “SYMBOLS” before
using this rotary tool.
Every time you use the rotary tool
you should verify the following:
1. The accessory is in good
condition and not damaged in
any way.
2. The workpiece is properly
secured.
3. Safety glasses are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury.
To Next Page
Loading...
Need help?
General
