20 performaxopeners.com Customer Service: 1-877-436-4402
SETTING THE FORCE
Once UP and DOWN limits are set, ensure both UP and
DOWN LEDs are illuminated. *if necessary toggle “Limit”
button until both LEDs are illuminated*
Press and release the “Force” button once. Door will
automatically travel one complete cycle followed by
flashing of the “OK” LED and 3 beeps. Programming is now
complete.
The door will travel
UP automatically.
Door will then
travel DOWN
automatically.
Stop at UP limit for 2
seconds.
OK indicator (orange)
will flash with beeps,
Auto Force Setting is
completed.
Flash and 2
beeps
To prevent SERIOUS INJURY or DEATH from
improper Force Adjustment:
• YOU CANNOT adjust force manually to compensate
for binding or sticking of the garage door. Call
a qualified garage door service person to make
necessary adjustments in case of binding.
• YOU CANNOT manually increase the force required
for closing the door.
• Aer ANY adjustments, Safety Reversal Test (see
page 21) MUST be performed to ensure the door
reverses on contact with a 1-1/2 inch (3.8 cm) high
object (2x4 laid flat).
2 sec
WARNING
NOTICE:
Travel limits and auto force setting must be set for
the opener to work. All steps on pages 18-20 must
be followed.
To Next Page
Loading...