• Shutdown Lamp
• Warning Lamp
• Wait to Start Lamp
• Low Oil Pressure Lamp
For information, refer to this manual, “Monitoring
System (Table for the Indicator Lamps)” for the
sequence of operation of the shutdown lamp and the
warning lamp.
The function of the wait to start lamp is automatically
controlled at engine start-up.
The function of the low oil pressure lamp is controlled
by the engine ECM. If low oil pressure is detected,
the lamp will be illuminated. The reason for the
illumination of the low-pressure lamp should be
investigated immediately.
All lamps will illuminate for 2 seconds in order to
check that the lamps are functioning when the
keyswitch is turned to the ON position. If any of the
lamps stay illuminated, the reason for illumination
should be investigated immediately.
The glow plug warning lamp will flash in order to
show that the engine is been held at low speed. This
function will be performed at engine starting and the
duration will depend on ambient temperature and
engine temperature.
Instrument panels and Displays
In order to monitor the engine a wide verity of
instrument panels are available. These instrument
panels can contain the indicator lamps and the
gauges for the application.
Also available are mini power displays and
performance monitors. These displays and monitors
can show the operator the following engine
information.
• The system configuration parameters
• The customer specified parameters
• Diagnostic codes
• Event codes
• Coolant temperature
• Oil temperature
• Oil pressure
• Intake temperature
• Intake pressure
• Fuel temperature
i02330192
Monitoring System
30
SEBU8731-04
Operation Section
Monitoring System
To Next Page
Loading...
