EasyManua.ls Logo

Perkins 1106D-E70TA - Page 75

Perkins 1106D-E70TA
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
i09570426
Battery or Battery Cable -
Disconnect
The battery cables or the batteries should not be
removed with the battery cover in place. The bat-
tery cover should be removed before any servic-
ing is attempted.
Removing the battery cables or the batteries with
the cover in place may cause a battery explosion
resulting in personal injury.
1. Turn the start switch to the OFF position. Turn the
ignition switch (if equipped) to the OFF position
and remove the key and all electrical loads.
2. Open the battery isolator. Disconnect the negative
battery terminal. Ensure that the cable cannot
contact the terminal. When four 12 volt batteries
are involved, two negative connections must be
disconnected.
3. Remove the positive connection.
4. Clean all disconnected connection and battery
terminals.
5. Use a fine grade of sandpaper to clean the
terminals and the cable clamps. Clean the items
until the surfaces are bright or shiny. DO NOT
remove material excessively. Excessive removal
of material can cause the clamps to not fit
correctly. Coat the clamps and the terminals with a
suitable silicone lubricant or petroleum jelly.
6. Tape the cable connections to help prevent
accidental starting.
7. Proceed with necessary system repairs.
8. To connect the battery, connect the positive
connection before the negative connection.
i04907925
Belt Tensioner - Check
Illustration 35 g03074016
Typical example
Remove the belt. Refer to Disassembly and
Assembly, “Alternator Belt - Remove and Install”.
Ensure that the belt tensioner is securely installed.
Visually inspect the belt tensioner (1) for damage.
Check that the pulley on the tensioner rotates freely
and that the bearing is not loose. Some engines have
an idler pulley (2). Ensure that the idler pulley is
securely installed. Visually inspect the idler pulley for
damage. Ensure that the idler pulley can rotate freely
and that the bearing is not loose. If necessary,
replace damaged components.
Install the belt. Refer to Disassembly and Assembly,
“Alternator Belt - Remove and Install”.
SEBU8731-04
75
Maintenance Section
Battery or Battery Cable - Disconnect

Other manuals for Perkins 1106D-E70TA

Related product manuals