Ensure that the engine cannot be started while
this maintenance is being performed. To help pre-
vent possible injury, do not use the starting motor
to turn the flywheel.
Hot engine components can cause burns. Allow
additional time for the engine to cool before
measuring/adjusting valve lash clearance.
Ensure that the engine is stopped before measuring
the valve lash. To obtain an accurate measurement,
allow the valves to cool before this maintenance is
performed.
Refer to Systems Operation, Testing, and Adjusting,
“Engine Valve Lash - Inspect/Adjust” for more
information.
i02683336
Fan Clearance - Check
There are different types of cooling systems. Refer to
the OEM for information on clearance for the fan.
Ensure that the engine is stopped. Ensure that the
cooling system is full. The clearance between the
cover (1) and the fan (2) will require checking. The
gap (A) between the edge of the cover and the tip of
the fan blade must be checked in four equally spaced
positions.
90
SEBU8731-04
Maintenance Section
Fan Clearance - Check
To Next Page
Loading...
