In most cases, stopping the engine will not be
necessary because of an intermittent code. However,
the operator should retrieve the logged fault codes
and the operator should reference the appropriate
information. in order to identify the nature of the
event. The operator should log any observation that
could have caused the lamp to light.
• Low power
• Limits of the engine speed
• Engine vibration or engine noise
This information can be useful to help troubleshoot
the situation. The information can also be used for
future reference. For more information on diagnostic
codes, refer to the Troubleshooting Guide for this
engine.
i05142533
Configuration Parameters
System configuration parameters affect the
emissions of the engine or the power of the engine.
System configuration parameters are programmed at
the factory. Normally, system configuration
parameters would never change through the life of
the engine. System configuration parameters must
be reprogrammed if an Electronic Control Module
(ECM) is replaced. System configuration parameters
are not reprogrammed if the ECM software is
changed.
For more information, refer to Troubleshooting,
“System Configuration Parameters”.
SEBU9075-03
45
Operation Section
Configuration Parameters
To Next Page
Loading...
Need help?
General
