Illustration 83 g06446752
Typical example
5. Tighten drain valve (2) securely and ensure that
drain valve outlet (3) is dry.
6. Remove the container and dispose of all fluids
according to local regulations and mandates.
7. Connect harness assembly (4) to the fuel filter
assembly.
8. The secondary fuel filter element must be replaced
at the same time as the primary fuel filter element.
Refer to this Operation and Maintenance Manual,
“Fuel System Secondary Filter - Replace” for more
information.
9. Turn the fuel supply valve (if equipped) to the ON
position after performing this maintenance.
i07820721
Fuel System Primary Filter/
Water Separator - Drain
(Primary Fuel Filter With Water In
Fuel (WIF) Sensor)
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Note: Refer to Systems Operation, Testing, and
Adjusting, “Cleanliness of Fuel System
Components” for detailed information on the
standards of cleanliness that must be observed
during ALL work on the fuel system.
NOTICE
Ensure that the engine is stopped before any servic-
ing or repair is performed.
NOTICE
The water separator is not a filter. The water separa-
tor separates water from the fuel. The engine should
never be allowed to run with the water separator
more than half full. Engine damage may result.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting, and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
M0094137-02 109
Maintenance Section
Fuel System Primary Filter/Water Separator - Drain
To Next Page
Loading...