Install the Canister Fuel Filter
Illustration 90 g06545420
1. Ensure that O-ring seal (2) is in position on fuel
filter (3). Lubricate the O-ring seal with clean
diesel.
2. Install fuel filter (3) to fuel filter base (1) and tighten
the fuel filter hand tight.
Note: Do not use a tool to tighten the fuel filter.
3. Close drain valve (4).
4. Turn the fuel supply valve (if equipped) to the ON
position
5. The primary fuel filter the secondary fuel filter must
be replaced at the same time. Prime the fuel
system, refer to this Operation and Maintenance
Manual, “Fuel System - Prime”.
i06541262
Fuel System Secondary Filter/
Water Separator - Drain
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Illustration 91 g06014499
Typical example
1. Place a suitable container below filter. Open drain
valve (1) and allow fluid to drain.
2. When necessary, close drain valve (1) with hand
pressure only.
The procedure must be performed with primary fuel
filter drain. Refer to this Operation and Maintenance
Manual, Fuel System Primary Filter/Water Separator
- Drain for more information.
i02348492
Fuel Tank Water and Sediment
- Drain
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Fuel Tank
Fuel quality is critical to the performance and to the
service life of the engine. Water in the fuel can cause
excessive wear to the fuel system.
M0094137-02 113
Maintenance Section
Fuel System Secondary Filter/Water Separator - Drain
To Next Page
Loading...