Commercial Glasswasher Installation & Operation Manual
Printed in USA 15
Troubleshooting
TECHNICAL ISSUE CAUSE SOLUTION
With power on, activating start switch
does not begin cycle
Defective start switch (cycle light will not light
either)
Replace start switch
Defective timer assembly Replace timer assembly*
Start switch requires > 1 second
activation to run cycle
Defective (Instant Start) ice cube relay Replace ice cube relay
Activating fill switch does not
fill machine
Defective drain/ ll switch Replace drain/ ll switch
Defective water solenoid valve Replace water solenoid valve
Fill (rinse water) won’t shut o
Defective water solenoid valve Replace water solenoid valve
Defective drain/ ll switch Replace drain/ ll switch
Defective timer assembly Replace timer assembly*
Defective (Rinse Relay) ice cube relay Replace ice cube relay
Activating drain switch does not drain
machine
Drain hose is kinked Un-kink drain hose
Defective drain/ ll switch Replace drain/ ll
Cycle light does not light while
cycle runs
Defective cycle light Replace cycle light (green)
Power light does not light but
machine runs
Defective power light Replace power light (red)
Wash tank or nal rinse temperature
does not display
Defective digital thermometer Replace digital thermometer
Both the wash tank temperature and
the nal rinse temperature do not
display
Defective thermometer transformer
Replace thermometer
transformer
Wash tank or nal rinse displays wrong
temperature
Defective digital thermometer Replace digital thermometer
Defective thermister Replace thermister
* The timer assembly motor or micro switches can be replaced independently if those are the only components that have
failed.
To Next Page
Loading...