Why does my Permobil Wheelchair stop while being driven?
If your Permobil Wheelchair unexpectedly stops while you're driving, it could be due to a loose cable connection to the control panel. Make sure the cable is securely inserted. Another possibility is that the main fuse has triggered.
What to do if my Permobil K300 Wheelchair cannot be started?
If your Permobil Wheelchair won't start, there are a few potential causes. First, the batteries might be discharged, so try charging them. Another reason could be a loose cable connection to the control panel; ensure the cable is properly inserted into the control panel. Also, check if the main fuse is switched to the OFF position (this can happen after a battery replacement) and reset it.
What to do if battery voltage indicator is blinking and Permobil Wheelchair can not be driven?
If the battery voltage indicator on the control panel is blinking once every 2.5 seconds and the Permobil Wheelchair cannot be driven, the control system might be in Sleep Mode. Switch the Start button on the control panel off and on again.
Why Permobil K300 Wheelchair can not be driven?
Your Permobil Wheelchair might not drive if the battery charger is connected, the wheel locks are activated, or the wheelchair is locked. Terminate the charging and remove the charging cable from the charging outlet. Reset the wheel locks and unlock the wheelchair.
General| Type | Power Wheelchair |
|---|---|
| Weight Capacity | 300 lbs |
| Maximum Speed | 5 mph |
| Range | 15 miles |
| Caster Wheel Size | 6" |
| Ground Clearance | 3" |
| Seat Width | 16" - 20" |
| Seat Depth | 16, 18 inches (40.6, 45.7 cm) |
| Suspension | Yes |
| Tires | Pneumatic or solid tires |
| Drive Type | Rear Wheel Drive |
To Next Page
