What does Bad Settings mean on Permobil C500?
This occurs when the control system detects incorrect or invalid program settings. Check all parameter settings and then reprogram the control system of your Permobil Wheelchair with the help of R-net’s PC programmers.
What to do if Permobil C500 Wheelchair cannot be charged?
If your Permobil Wheelchair cannot be charged, it could be due to the main fuse being switched to the OFF position, possibly after a battery replacement. Reset the main fuse to resolve this. Another cause might be a triggered charging fuse, potentially due to a fault in the batteries, charger, charging cables, or charging socket. Carefully check these components before replacing the charging fuse.
Why does my Permobil C500 Wheelchair switch off by itself?
If your Permobil Wheelchair switches off after a period of inactivity, it's likely that the electronics' energy-saving mode has been activated. Simply switch the wheelchair back on using the start key on the control panel.
Why Permobil C500 Wheelchair drives at reduced speed?
If your Permobil Wheelchair can only be driven at a reduced speed and you have an electric seat lift and seat angle, it might be because the seat lift or seat angle is raised too high. Lower the seat lift or seat angle to resolve this.
What does Inhibit Active mean on Permobil Wheelchair?
This occurs when one of the inhibit signals is active and is in blocked mode. Cycle the voltage of your Permobil Wheelchair. This will deactivate the block mode, which may remedy the error.
What does Brake Lamp Short mean on Permobil C500?
This occurs when the control system detects a short circuit in the brake lamp electrical circuit of your Permobil Wheelchair. Check the brake lamps, their cables, and the connections to the control system.
What to do if my Permobil C500 cannot be driven?
If your Permobil Wheelchair cannot be driven, ensure the battery charger is disconnected from the wheelchair’s charging socket. Also, check that the brake release is reset. Finally, verify that the wheelchair is unlocked.
Why does my Permobil C500 show a Low Battery error?
If the control system detects that the battery voltage is lower than 16 V, this could be the reason. Check the batteries and their connection to the control system of your Permobil Wheelchair.
What does Lamp Short mean on Permobil C500 Wheelchair?
This occurs when the control system detects a short circuit in the electrical circuit of one of the lamps of your Permobil Wheelchair. Check the lamps, their cables, and the connections to the control system.
How to fix Permobil C500 Wheelchair that won't start?
If your Permobil Wheelchair won't start, the batteries may be discharged. To resolve this, charge the batteries. Also, ensure the cable connection to the control panel is secure by inserting the cable into the control panel. Another potential cause is that the main fuse might be switched to the OFF position, especially after a battery replacement. If so, reset the main fuse.
Provides contact addresses, phone numbers, and emails for Permobil USA and Sweden.
Covers manual usage, technical support, parts, warranty, and scrapping details.
Covers fundamental safety guidelines, warning symbols, and general operation.
Details safe driving practices, inclines, turning, and environmental factors.
Addresses safety for seat functions, transport, maintenance, electrical systems, and battery handling.
Introduces the Permobil C500, its parts, and primary systems like seat and drive.
Explains the Pilot+ and R-Net control panels, joysticks, displays, and their functions.
Details seat adjustments, locking mechanisms, and the LCD screen interface.
Guides on driving, techniques, rules, and safely navigating obstacles and slopes.
Covers manual wheel lock operation and correct battery charging methods.
Details safe vehicle securing, prohibited uses, and air transport advice.
Covers general maintenance, tool kit, battery care, and storage.
Provides procedures for tire replacement, fuse replacement, and circuit breaker reset.
Lists physical dimensions, weight, and performance capabilities of the wheelchair.
Details specifications for the Pilot+ and R-Net electrical systems and components.
Provides a guide for common events, their causes, and suggested solutions.
Explains error signals from the battery indicator and troubleshooting steps.
Guides on diagnosing system trips and interpreting diagnostic screens.
Explains system logs, error code definitions, and component testing procedures.
Outlines procedures for servicing defective R-net control system units.
Explains EMI, its impact on the wheelchair, and necessary precautions.
Informs about available accessories and how to get more details from a retailer.
General| Drive Type | Rear-Wheel Drive |
|---|---|
| Drive System | Rear-Wheel Drive |
| Tires | Pneumatic or Solid |
| Range | 20 miles |
| Weight Capacity | 300 lbs |
| Ground Clearance | 3 inches (7.6 cm) |
| Warranty | 2 years |
| Caster Wheel Size | 8 inches (20.3 cm) |
To Next Page
