What to do if my Permobil C500 Wheelchair stops while being driven?
If your Permobil Wheelchair stops while being driven, it could be due to: * A loose cable connection to the control panel: Attach the cable to the control panel. * A Triggered Circuit Breaker: Check possible causes.
Why my Permobil C500 can not be driven?
Your Permobil Wheelchair might not be drivable due to a few reasons: * The battery charger is connected: Terminate the charging and remove the charging cable from the charging outlet. * Wheel Locks are activated: Reset the Wheel Locks. * The wheelchair is locked: Unlock the wheelchair.
What to do if my Permobil C500 Wheelchair does not start?
If your Permobil Wheelchair doesn't start, there are several potential causes: * The batteries may be discharged: In this case, charge the batteries. * The cable connection to the control panel might be loose: Attach the cable to the control panel. * Circuit Breaker set in ”OFF” position: Reset the Circuit Breaker. * The Circuit Breaker might be triggered: Carefully check possible causes before resetting.
How to fix Permobil C500 Wheelchair that won't start?
If your Permobil Wheelchair won't start, the batteries may be discharged. To resolve this, charge the batteries. Also, ensure the cable connection to the control panel is secure by inserting the cable into the control panel. Another potential cause is that the main fuse might be switched to the OFF position, especially after a battery replacement. If so, reset the main fuse.
What to do if battery voltage indicator on Permobil Wheelchair is blinking once every 2.5 seconds?
If the battery voltage indicator on the control panel of your Permobil Wheelchair (Pilot+ only) is blinking once every 2.5 seconds and the wheelchair cannot be driven, the control system is likely in Sleep Mode. To resolve this, switch the Start button on the control panel off and on again.
Why Permobil C500 Wheelchair can only be driven with reduced speed?
If your Permobil Wheelchair can only be driven at a reduced speed (applies for electrical seat lift only), it might be because the seat lift is raised from its lowest position. Lower the seat lift to restore normal speed.
What to do if Permobil Wheelchair can not be driven?
If your Permobil Wheelchair cannot be driven, here are a few things to check: * Ensure the battery charger is disconnected and the charging cable is removed from the charging outlet. * Make sure the Wheel Locks are not activated; if they are, reset them. * Verify that the wheelchair is not locked; if it is, unlock it.
Why Permobil C500 won't start?
Your Permobil Wheelchair might not start due to several reasons: * The batteries may be discharged, in which case you should charge them. * The cable connection to the control panel might be loose, so ensure it is securely attached. * The Circuit Breaker might be in the ”OFF” position, especially after changing batteries, so reset it. * The Circuit Breaker may have been triggered. Before resetting, carefully check for any possible causes.
What does Brake Error mean on Permobil C500?
This happens when the control system detects a problem in the solenoid brakes or their connections. Check the solenoid brakes, their cables, and the connections to the control system of your Permobil Wheelchair.
What to do if Permobil C500 will not charge?
If your Permobil Wheelchair will not charge, it could be due to: * Circuit Breaker set in ”OFF” position: Reset the Circuit Breaker. * Triggered charging fuse: Carefully check possible causes before replacing.
General| Drive Type | Rear-Wheel Drive |
|---|---|
| Drive System | Rear-Wheel Drive |
| Tires | Pneumatic or Solid |
| Range | 20 miles |
| Weight Capacity | 300 lbs |
| Ground Clearance | 3 inches (7.6 cm) |
| Warranty | 2 years |
| Caster Wheel Size | 8 inches (20.3 cm) |
Provides contact addresses, phone numbers, and emails for Permobil USA and Sweden.
Covers manual usage, technical support, parts, warranty, and scrapping details.
Covers fundamental safety guidelines, warning symbols, and general operation.
Details safe driving practices, inclines, turning, and environmental factors.
Addresses safety for seat functions, transport, maintenance, electrical systems, and battery handling.
Introduces the Permobil C500, its parts, and primary systems like seat and drive.
Explains the Pilot+ and R-Net control panels, joysticks, displays, and their functions.
Details seat adjustments, locking mechanisms, and the LCD screen interface.
Guides on driving, techniques, rules, and safely navigating obstacles and slopes.
Covers manual wheel lock operation and correct battery charging methods.
Details safe vehicle securing, prohibited uses, and air transport advice.
Covers general maintenance, tool kit, battery care, and storage.
Provides procedures for tire replacement, fuse replacement, and circuit breaker reset.
Lists physical dimensions, weight, and performance capabilities of the wheelchair.
Details specifications for the Pilot+ and R-Net electrical systems and components.
Provides a guide for common events, their causes, and suggested solutions.
Explains error signals from the battery indicator and troubleshooting steps.
Guides on diagnosing system trips and interpreting diagnostic screens.
Explains system logs, error code definitions, and component testing procedures.
Outlines procedures for servicing defective R-net control system units.
Explains EMI, its impact on the wheelchair, and necessary precautions.
Informs about available accessories and how to get more details from a retailer.
To Next Page
