Owner´s Manual Permobil C500 Technical Specifications
74
Trouble Shooting Guide
The troubleshooting guide below describes a number of events that can arise
when you use your wheelchair, as well as providing suggestions for solutions.
Note that this guide does not describe all the possible events that can arise, and
you should always get in touch with your service contact or Permobil when you
are unsure.
The wheelchair does not start. Batteries discharged. Charge the batteries.
The cable connection to the Atttach the cable to the control
control panel has become panel.
loose.
Circuit Breaker set in ”OFF” Reset the Circuit Breaker.
position after, for example, See page 70.
changing batteries.
Triggered Circuit Breaker. Carefully check possible
causes before resetting.
See page 70.
The wheelchair can not Battery charger connected. Terminate the charging and
be driven. remove the charging cable
from the charging outlet.
Wheel Locks activated. Reset the Wheel Locks.
The wheelchair is locked. Unlock the wheelchair.
See page 34 alt. 40
Battery voltage indicator The control system is in Switch the Start button on the
on the control panel blinking Sleep Mode. control panel off and on again.
once every 2.5 seconds and
the wheelchair can not be
driven.
Only Pilot+!
Battery voltage indicator Fault indicated in the See pages 76-77.
on the control panel rapidly drive electronics. Alt. contact service.
blinking and the wheelchair
can not be driven.
Only Pilot+!
The wheelchair stops while The cable connection to the Atttach the cable to the control
being driven. control panel has become panel.
loose.
Triggered Circuit Breaker. See page 70.
EVENT POSSIBLE CAUSE SOLUTION
To Next Page
Loading...
