Perrot P2S - Description; Assembly

TDP057e.doc Rev.22.10.2014 Page4/11

PerrotREGNERBAUCALWGmbHIndustriestraße19‐29/D‐75382Althengstett/Germany
Phone:0049‐7051‐162‐0/Fax:0049‐7051‐162–133
E‐mail: perrot@perrot.de/E‐mailTechnicalDepartment:technik@perrot.de
3.Description

Recommendedoperatingpressure 5to7bar
Permissibleoperatingpressure  4to10bar

Thepressureatthesprinklermustnotexceed10bar.

Forfurtherdatapleaserefertotheseparatedataleaflet.

4.Assembly

 Threadedconnectiononthesprinkleris2½“femalethread.
 For sealing the thread, hemp and a jointing compound has to be used e.g. Fermit
special
 Toscrewonthesprinkler,alwaysuseapipewrenchsize3“.
Tightenthesprinklerwitharound30Nm.

Donotturnthesprinklerbyusingthejetpipe.


Sprinklersshouldbeinstalledabovehead‐height,respectivelyadoptany
alternativesafetymeasures.
picture1

Screw on the connection socket up to the detent, so that the sprinkler cannot unscrew
itselfduringoperation.
Pipewrench3“