Petcube Bites 2 Lite - Page 44

44
14. Petcube Bites 2 Lite factory reset instructions
If you have a problem with your Petcube and need to reset it, follow these easy steps:
First, if you have previously set up your Petcube:
1. Open the Petcube app;
2. Go to ‘Home’ tab;
3. Tap the ‘Settings’ wheel in the upper right corner;
4. Choose ‘Disconnect Camera’;
5. Power up your Petcube, wait 1 minute until it starts up;
6. Find a small button above the USB port on the left side of the Petcube Bites,
insert the reset pin into it, until you hear: «Ready for setup»;
7. Wait until the LED on the camera starts blinking;
8. Open Petcube app again;
9. Go to the ‘Home’ tab and select ‘Connect your device’;
10. Pick your Petcube from the list of options and follow the steps on the screen.