Note:
If LCD of Remote Transmitter does not display, there is probably two reasons:
Fit the Receiver Collar with your dogs:
Attaching the Contact Points
In your package that you received, you will find 1 set of contact points. These
contact points are screwed onto the receiver so that the points can effectively
contact the dog's skin without hair/fur interfering with the connection.
Important: The proper fit and placement of your collar is important for effective
training. The Contact Points must have direct contact with your pet's skin on the
underside of the dog's neck.
To assure a proper fit, please follow these steps:
1) Have your pet standing comfortably (3A).
2) Centre the Contact Points underneath your pet's neck, touching the skin (3B).
If your pet has a long or thick coat, please use longer Contact Points.
CAUTION: There are 16 levels for Vibration and Stimulation. The strong
Stimulation can penetrate the hair of the pet and fabric within 6mm thick.
Do not shave the pet's neck as this may increase the risk of skin irritation.
3) The Collar should fit snugly, yet loose enough to allow one finger to fit between
the strap and your pet's neck (3C).
4) Allow your pet to wear the collar for several minutes then recheck the fit.
Check the fit again as your pet becomes more comfortable with the Collar. If
your pet's neck is less than 12”around, you will need to thread the part of the
collar through the buckle. It will be a tight fit.
CAUTION: Risk of skin damage.
For comfort, safety and effectiveness of this product. Please ensure that you
check the fit of your pet's collar frequently. If any skin irritation is observed,
discontinue the use of the collar for a few days. If the condition persists beyond
48 hours, see your veterinarian.
Do not attach a leash to the Collar. This can result in pulling the Contact Points
The Receiver Collar is not designed to be worn constantly. We recommend the
Collar not be worn for more than 12 hours out of every 24-hour period.
Most pets feel uncomfortable at first wearing the collar. Don't use any functions
until the pet has gotten used to the collar.
We suggest you give the dog Vibration before starting the Static Shock. After a
too tightly against your pet's neck. You may put a separate nonmetallic collar on
your dog's neck and attach a leash.
time of training, the dog will learn that Static Shock Stimulation will come after
Vibration. In this way, the vibration alone can effectively curb the improper deeds
of the pet. The Stimulation only acts as a menace that might be unnecessary
most of the time.
5) Regular Maintenance
Check Contact Points for tightness weekly.
Clean Contact Points with alcohol weekly.
Note: Check your dog's neck for irritation and wash neck weekly.
1. Deep Sl e e p : I n o r der to save p o w e r, t h e R e mote Tran s m i t t e r will go int o
Standby Mode if there is no operation after 1 minute, press any button except
Up/Down Button to activate Remoter Transmitter, LCD will display.
2. Power off: In order to save power, you ca n p r e s s a n d h o l d t h e “Channe l l
-12- -13-
(Figure 6-3)
(1/ 2)Button” for more than 3 seconds for power off the Remote Transmitter.
If the Remote Transmitter power off, only press and hold the“Channell(1/ 2)
Button” for more than 3 seconds for power on it.
To Next Page
Loading...