FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Troubleshooting
My pet does not respond after correct installation Rechargeable and Waterproof
Training Collar.
You need to charge the Remote Transmitter and Receiver Collar for 2 hours individually
first.
You need to turn on the Remote Transmitter by holding the Channel Button for 3
seconds.
Check the levels of vibration or static shock.
Make sure the Receiver has enough power to operate.
Restart the Receiver collar by charging it.
Test 3 functions (Beep, Vibration and Shock) first before using. See part“Test” of
Operation Guide.
Make sure the Contact Points are placed snugly against your pet's skin.
Trim your pet's fur where the Contact Points touch the neck or switch to the longer
Contact Points.
If none of the above works, you can try repairing between the Remote Transmitter
and Receiver Collar. (See part “Pairing” of Operation Guide)
Remote Transmitter does not work.
You need to charge the Remote Transmitter for 2 hours when you get product for the
first time.
Check if the Remote Transmitter is on low battery status, the symbol will show up on
the right side of the LCD screen.
You need to hold the Channel Button on the Remote Transmitter for 3 seconds to
power it the device on.
Remote Transmitter automatically goes into standby mode if no action is detected
within 1 minute, at this time there will be no LCD display. Press any button to re-activate
the Remote Transmitter.
Remote Transmitter does not work.
If you test Receiver Collar by your hand or leg, please touch the 2 electrodes at the
same time, only touching one electrode will not work.
-16- -17-
To Next Page
Loading...