petsafe.com14
ENFRES
NL
IT
DE
Step 7: Prepare the Receiver Collar
In order to test the system you will need to use the receiver collar. Your receiver
collar comes installed with short contact points. If your pet has long or thick hair,
use the long contact points instead. Tighten or switch the contact points by using
the test light tool (7A).
Turn the Receiver Collar On
To turn on the receiver collar, press and hold the mode button continuously for
5 seconds (7B). The receiver indicator light will turn on for 5 seconds to indicate
battery status (green, yellow or red), followed by a series of red flashes which
represent the static stimulation level.
Turn the Receiver Collar Off
To turn off the receiver collar, press and hold the mode button continuously for
5 seconds (7B). The red receiver indicator light will be on during this time. The red
receiver indicator light will then turn off and all receiver indicator lights will stay
off indicating that the unit is turned off. To extend the time between charging the
receiver collar, consider turning off the receiver collar when it is not in use.
Receiver Collar Status Indicators
The receiver collar status indicator light, along with the receiver collar alarm
tone, are used to determine the battery status and the stimulation type. Refer to
the receiver collar status indicator table below to understand the status lights and
tones for the receiver collar. During normal operation, the receiver collar indicator
light will flash every 4–5 seconds to indicate the battery status as shown in the following table.
Receiver Collar Status Indicator Table
Light Status Alarm Tone Condition
While Plugged into the Receiver Charger
Solid red No tone Charge in progress
Solid green No tone Charge complete
No light –
Charge failure, contact
Customer Care Centre
After Removing from the Receiver Charger
Continuous green, yellow or red
(5 seconds duration)
No tone
Battery charge indication;
Occurs immediately after
unplugging the charger from the receiver collar
Operating Battery Status
Slow blinking green
(every 4–5 seconds)
No tone Collar battery charge 100%–60%
Slow blinking yellow
(every 4–5 seconds)
No tone Collar battery charge 60%–20%
Slow blinking red
(every 4–5 seconds)
No tone Collar battery charge 20% or less, charge immediately
Receiver Activation Status
Fast pulsating green
(3 flashes per second)
Warning tone Warning tone
Fast pulsating red
(3 flashes per second)
Tone for duration of static
stimulation
Static stimulation being delivered up to 15 seconds
Continuous green
(10 seconds)
No tone Over-stimulation protection; collar locked for 10 seconds
7A
Mode Button/
Receiver Indicator Light
7B
To Next Page
Loading...
