PetSpy M86N - Training Tips and Troubleshooting; General Training Advice; Troubleshooting Common Issues; Maintenance and Storage

GENERAL TIPS
• PetSpy Dog Training Collar is not design to be worn constantly. We recommend you
to limit collar usage just for active Training Sessions. Always take o the collar when
you leave your dog unattended.
• Most dogs will feel uncomfortable when wearing collar for the rst time. Don’t use
any commands until your dog has gotten used to the collar which will normally take
several days.
• Eliminate one unwanted action or teach one obedience command at a time. If you
move to quickly with training, your dog may become confused.
• Be consistent in your training. Give your dog the same stimulation for each unwanted
action. We suggest you to use Vibration Stimulation before starting the Static Shock
Stimulation. If you follow this training method, your dog will learn that Static Shock
Stimulation might come aer Vibration. Hence, the Vibration Stimulation alone can
eectively cure unwanted behavior of your dog.
• Do not over-correct. Use as few stimulation as possible to train your dog.
• Following a predened scenario in all Training Sessions can dramatically improve
your chances of success.
• Should your dog react to the training by hiding or reacting fearfully, redirect his atten-
tion to a simple command such as “Speak” or “Sit” to calm him down. Use treats to help
your dog understand which commands have been done correctly.
TROUBLESHOOTING
My PetSpy Advanced Dog Training Collar is not working?
•Make sure that both the Remote Transmitter and Receiver Collar are fully charged.
•Move or shake the Receiver Collar to make sure that green LED light starts ashing
every 4-5 seconds.
•Please follow the steps from Synchronizing Remote Transmitter with Receiver Collar
paragraph to make sure that transmitter is in sync with the collar.
CAUTION: While the Receiver Collar is waterproof, the Remote Transmitter is not and
must be kept in a dry place! Water can irreversibly damage the Remote Transmitter!
REGULAR MAINTENANCE AND STORAGE
•When not used, PetSpy Dog Training System must be kept in a dry place just like any
other electronic devices.
•To prevent batteries from damage, charge both the Transmitter and Receiver regularly
even when it’s not used. Make sure you do not charge it for longer than 30 minutes.
•Clean the receiver and contact points weekly. Make sure that contact points are tightly
attached to the collar
•Check your dog’s neck for irritation weekly.