8
Notes & FAQ:
a) When the bowl is rotating both the clock setting and mode setting are not allowed
b) Under clock display mode the colon icon (:) will flash. The colon icon (:) is turned
Off when in feeding timer mode
c) A PM icon will be displayed in the afternoon under 12-hour clock mode and turned
off in the AM. The PM icon will not be displayed under 24 hour clock mode
d) In feeding timer mode, three numbers will show up, the first number is the feeding
number (1,2,3,4,5 or 6) and last two digits indicate the feeding time in hours
e) When the feeding timer starts, the BELL icon will turn On. Under feeding-timer
display mode a solid BELL icon means the feeding time has already passed. A
flashing BELL icon means the feeding time has not been reached. This lets the
user know how many feedings are left for feeding
f) If the time for the next feeding is set earlier than the present feeding time, the
feeding will start the next day
g) If the Mode key is pressed and held for more than 2 seconds the number will
rapidly increase automatically until you release the key. When number reaches its
maximum, the number will fall back to the minimum value and start increasing
again
h) If the feeding timer has already begun, pressing the START key will reset the
timer and begin again from the 1
st
feeding-time set
i) If START TOMORROW key is pressed, both the BELL and Zz icon will be ON.
The Zz icon will turn OFF at 0:00 midnight to indicate the timer has started
j) START TOMORROW is used should you want to set your feeder up today and
have it start tomorrow. This is good for when you have programmed feeding times
that have yet to pass so you can prepare in advance for a possible trip or just
being away the next day and not wanting the feeder to run the day you
programmed it
Rev-1.1
1
Quick Start Guide
Automatic 6 Meal LCD Clock Pet Feeder (PF-18)
Control Panel Keys
MODE - switches between clock or feeding time display. Also increases clock time
during clock / feeding time Set mode
SET – enters settings mode. Also confirms the time you enter and advances to
next setting
START NOW – starts the feeding timer immediately
START TOMORROW- starts the feeding timer the next day
REC – records your personal voice message
PLAY – plays back your recorded voice message
ON SWITCH – turns the feeder on / off. For when the feeder will not be used for
an extended period of time. Turning this switch off will RESET all time and feeding
settings
Getting Started
1. Carefully turn the pet feeder upside down. Remove both battery doors by
squeezing the two tabs and gently pulling each door away
2. Keep the ON switch set to OFF
3. Insert four C size alkaline batteries into the battery tray. Do NOT use old or
-cheap- carbon batteries
4. Close the battery doors, rotate the feeder right-side up and switch ON
5. The feeder will cycle one time until “12:00” is on the LCD display
Note: Your pet feeder makes the food available in this sequence: Tray 1, Tray 2, Tray
3 to Tray 6. When you want only one feeding, you should fill only Tray 1; for only 2
feedings, fill Trays 1 and 2 and so on.
1. Setting the current Clock time
1) During Clock display mode, press and hold the SET key for (2 seconds) to enter
Clock SET mode. The hour number will now be blinking
2) Press the MODE key to increase the hour. Once you have set the hour, press the
SET key to confirm the hour. The minute number will now blink
3) To change the minute number, press the MODE key to increase the minute. Once
you have set the minute, press the SET key to confirm the minute. Both the hour
and minute numbers will now blink
4) If needed, Press the MODE key to change between 12 or 24 hour time.
5) Press the SET key to confirm your current time setting and the numbers will stop
blinking
To Next Page
Need help?
General