Setting up
13
4 Setting up
4
.01 Entering the puller feed stroke (stitch length)
● Switch on the machine.
● Enter the feed stroke by pressing the corresponding +/- key.
The puller feed stroke setting must match the stitch length setting of the basic
machine!
4.02 Setting the puller pressure
● Switch on the machine.
● Set the desired puller pressure by pressing the corresponding +/- key.
The value for the current puller pressure (in %) can be read on the display.
4000 PUL 30%
2.0mm
Speed
4000 PUL 30%
2.0mm
Speed
To Next Page
Loading...
Need help?
General
