To Next Page

To Previous Page

Standard Presser Foot 0

This foot is used mainly for straight stitching and zigzag stitching

with a stitch length longer than 1.0 mm.

Clearview Foot 1

When sewing decorative stitches or short zigzag stitches and

other utility stitches with less than 1.0mm stitch length, use this

IRRW7KHJURRYHRQWKHXQGHUVLGHRIWKHIRRWLVGHVLJQHGWRÁRZ

smoothly over the stitches.

Four-Step Buttonhole Foot 5A (for 140s)

6OLGLQJSODWHXQGHUIRRWKDVFRQYHQLHQWO\VSDFHGPDUNLQJVWRVWDUW

and stop your buttonhole at precisely the correct point.

Blindhem Foot 3

This foot is used for blindhem stitches. The toe on the foot guides

the fabric. The red guide on the foot is designed to ride along the

fold of the hem edge.

Note: Always use at least 5mm stitch width when using Blind Hem Foot

3. If using a stitch width other than the recommended, swing the needle

by turning the hand wheel to make sure the needle doesn’t hit the metal

pin in the foot.

One-Step Buttonhole Foot 5B (for 160s)

This foot has a space in the back for a button used to set the size of

WKHEXWWRQKROH7KHPDFKLQHZLOOVHZDEXWWRQKROHWRÀWWKDWEXW-

ton size.

Zipper Foot 4

This foot can be snapped on either the right or the left of the nee-

dle, making it easy to sew close to both sides of the zipper teeth.

Move the needle position to the right or left to sew closer to zipper

teeth.

Presser Feet

Pfaff 160S User Manual

Questions and Answers: