Threading the machine
Make sure that the presser foot is raised and the needle
is in its highest position.
1. Place the thread on the spool pin and fit the
appropriately sized spool cap.
2. Pull the thread into the thread guide (A) from front
to back and thread guide (B) from back to front. Pull
the thread between the tension discs (C).
3. Thread down through the right-hand threading slot
and then upwards through the left-hand threading
slot.
4. Bring the thread from the right into the take-up lever
(D) and down in the left-hand threading slot, into
the lower thread guide (E) and to the needle thread
guide (F).
5. Thread the needle.
13
To Next Page
Loading...
Need help?
General
