10
8 Checks
8.1 Oil level in the sewing machine
When necessary, fill by pouring oil through hole 1 (fig. 1) in the oil-level sight glass.
We recommend Pfaff sewing-machine-oil, article number 280-1-120 or an oil with a
mean viscosity of 22.0 mm
2
/s at 40°C and a density of 0.865 g/cm
3
.
8.2 Direction of rotation
Requirement: The handwheel must turn in the direction of the arrow (fig. 2).
.1 Switch on the machine.
.2 Lift the presser foot with the hand lever.
.3 Press the foot pedal lightly (+1) forwards (fig. 3).
.4 If the direction of rotation is wrong, see the technical literature from the motor manufacturer;
parameter 800.
9 Inserting the needle
.1 Switch the machine off (mains switch).
.2 Slide the needle bar into position until it stops (long groove facing the operator).
10 For your attention before the initial operation
Oil the connections (arrows in fig. 4) of the top feed a little.
For the first 2 weeks of operation, only run the machine up to 3/4 of its maximum
speed.
To Next Page
Loading...
