Pfaff 910 Series

Table of Contents
Contents...............................................................................Chapter - Page
1 Safety ........................................................................................................................ 1 -1
1.01 General notes on safety............................................................................................. 1 -1
1.02 Safety symbols .......................................................................................................... 1 - 2
1.03 Danger .......................................................................................................................1- 2
2 Adjustment ............................................................................................................... 2 - 1
2.01 Notes on adjusting ..................................................................................................... 2 - 1
2.02 Tools, gauges and other accessories ......................................................................... 2 - 1
2.03 Abbreviations ............................................................................................................. 2 - 1
2.04 Work symbols ............................................................................................................ 2 - 1
2.05 Check and adjustment aid.......................................................................................... 2 - 2
2.06 Pre-adjusting the control cam .................................................................................... 2 - 3
2.07 Roller lever.................................................................................................................2- 4
2.08 Pawl ........................................................................................................................... 2 - 5
2.09 Engaging solenoid...................................................................................................... 2 - 6
2.10 Release lever ............................................................................................................. 2 - 7
2.11 Engaging lever ........................................................................................................... 2 - 8
2.12 Thread catcher position and cutting test.................................................................... 2 - 9
2.13 Control cam (final adjustment) and retaining spring ................................................... 2 -10
2.14 Needle thread tension release ................................................................................... 2 -11
2.15 Removing and refitting control unit............................................................................ 2 -13
2.16 Synchronizer .............................................................................................................. 2 -14