Pfaff coverlock 4872 User Manual

Thread
chain cutter
After finishing the seam,
sew
an
approx.
6”
-8” (15 -20
cm>
long thread chain. Pull
the thread chain from
the back to the front
over the thread
chain cutter 40. This will
cut
off the thread chain.
Cbmp spring for serging thread chain
32
Using this
feature
you can serge the thread
chain at the start of the fabric,
by
pulling
it
into the seam. Stitch off
a
minimum
4”
(10
cm>
long thread
chain and raise the
presser foot. Remove the thread chain
care
fully from the swiveling stitch width latch
27. Pull the thread chain forwards
and
clamp
it
under
the
spring.
This
feature
cannot
be used for either the
five-thread safety-stitch seam,
the four-
thread safety-stitch seam,
the
two-thread
chainstitch or for the rolled
hem.
I
Place the fabric right in front
of the
needle(s).
If necessary,
make an approx.
1.5” (3cm>
cut
into the fabric
along the
cut-line using
a pair
of
scissors. Lower the
presser foot and start sewing.
The thread
chain pulls automatically
into the inside of
the
seam.
Note:
30

Pfaff coverlock 4872 Specifications

General

Brand	Pfaff
Model	coverlock 4872
Category	Sewing Machine
Language	English