Pfaff creative 1371

Border
1
prog
___
2935
-3+
2
First
workstep,
centre
motif
•
Select
program 35
Sew
the programmed
stitch pattern.
Second
workstep,
heart
motif
•
Select program
29
Sew
the programmed
stitch
pattern,
stitching
the
straight-stitch
seam
along
the centre
motif.
Border
2
prog-
04
30
:izLL.J
Begin by
tracing the pattern
on a piece
of
paper,
then
transfer it onto
the
fabric
First
workstep,
stems
•
Select
program
04
and sew
along
the
traced
lines.
Second workstep,
leaves
• Select
program 42
• Stitch
width 4.5
mm
• Pattern
lengths
12—10-9.0—8.0
•
Press ‘single
pattern’ key
• Sew
the
leaves, starting
at the stem.
Third workstep,
flowers
• Select
program
30
• Press
“single
pattern”
key
•
Press “needle
down” key
The
flowers are
produced
by
turning
the
fabric.
Sew
the programmed
stitch
pattern
until the
needle
stops down
in
the
material.
Turn
the fabric
through
90°. Repeat
this process
three times.
Fourth
workstep, flower
centre
•
Select
program
42
•
Stitch width
5.0 mm
• Stitch length
0.25
mm
•
Pattern
length
5.0
Sew the
programmed
stitch pattern
in the
middle,
as illustrated.
Fifth workstep,
bud
centre
• Select
program 42
•
Stitch
width
2.5 mm
•
Stitch length
0.25 mm
•
Pattern
length 3.0
Sew
the programmed
stitch
pattern,
as illus
trated.
2
45