4
1
2
3
This section describes how to thread the ribbon to
the base. For instructions about how to thread yarn or
beads into the base, see next section.
Turn the Embellishment Attachment over for easier
threading.
Once the ribbon is placed under the rst threading
guide on the spool holder, continue threading through
the second and third ribbon guide.
Thread the ribbon through the fourth adjustable
ribbon guide.
Thread Ribbon into the Base
Thread Yarn or Beads
into the Base
This section describes how to thread yarn or beads
into the base. Note that the images only show beads.
The process is similar for yarn.
Insert the end of the yarn or string of beads into the
eye of the threading wire. Carefully pull the yarn or
string into the smaller eye of the wire (1). This is to
hold the yarn in place whilst you pull it through the
threading channel.
When using beads, leave one bead outside the eye.
Place the threading wire over the rst threading guide
on the spool holder, then insert the wire into the
threading channel (2).
Pull the threading wire to draw the yarn through the
threading channel. Do not remove the yarn or string
of beads from the threading wire (3).
More instructions on how to thread the Embellishment attach-
ment is found in the respective technique tutorial.
While holding the ribbon in place rotate the wheel of the adjustable base until the edges of the base match the
width of the ribbon. Do not tighten too much, the ribbon should lay at. (If the opening in the adjustable base
is too tight, rst turn the wheel counter clockwise.)
Carefully pull out about 1½” (4 cm) of ribbon outside the Embellishment Attachment.
More instructions on how to thread the Embellishment attachment is found in the respective technique tutorial.
To Next Page
Loading...
Need help?
General
