2:12
A
B
C
D
Technical section
Threading the needle
Switch off the main switch
Raise the presser foot lifter (20). Place the thread on the
spool holder and À t a spool cap of the right size.
Using both hands, pull the thread into thread guide A from
the front. Place the thread from right to left into the pre-
tension device B. Now pass it through the left threading
slot downwards. Pull the thread around the stop C in the
right threading slot and upwards to the take-up lever (19).
The thread must be pulled into the take-up lever from left
to right. Pass the thread downwards in the right-hand
threading slot. Pull the thread from the side behind one of
the two thread guides D.
To thread the needle, please refer to the next page.
To Next Page
Loading...
Need help?
General
