Pfaff tipmatic 6152 User Manual

e
a
'""
....,
iii
~
c:
iii
~
iii
I!I
n::
/\.
~
VoN
,--...
~
prog
I
- .... -
~
v
l a
H
2.5 5~
•
3-5 3
Ib
H
2.5 5~ - 3-5 3
Blind stitch
Blind stitch H is best suited for invisible
hems; sewing by hand is no longer necessary.
-
Serge the edge of the hem.
- Fold
the edge inwards by the hem w i dth .
-
Now unfold the hem again so that the hem
edge protrudes by
about 1 cm.
-
Now place the fabric under the sewing foot
so that the crease line runs along edge
guide B.
- Using
the needle positioning knob (35),
select
the needle position to the right @ .
- When the needle enters the crease line, it
must only pick up one fiber of the fabric.
Remember!
If, when blind stitching with sewing foot No .
3, you se lect a position other than needle
position
.,right" @ and stitch width 5, make
sure
that the needle does not strike the bar of
the sewing foot. Otherwise the needle will
break.
38
\
\
If the stitches are visible on the right side ,
adjust edge guide B by
turning adjusting
screw A.
If the needle position to the right @ is used,
using
the width knob (34) you can regulate
the penetration of the needle in the crease.
Program
0 is a blind stitch for elastic materi-
als. The hem is sewn and serged at the same
time, i.e.
it is not necessary to serge the fabric
edge.

Pfaff tipmatic 6152 Specifications

General

Brand	Pfaff
Model	tipmatic 6152
Category	Sewing Machine
Language	English