Philco PHAF 5000

To Next Page

To Previous Page

EN - 4

Attention: Hot surface

■ When the appliance is in operation, the temperature of accessible surfaces may be higher. Do

not touch the hot surface. Otherwise, this could cause burns. Use the handle to remove and

carry the hot pan and basket. Only place the hot pan and basket on heat resistant surfaces.

When removing the pan out of the appliance, be especially careful not to scald yourself by the

steam that is released from the food. The residual heat of the appliance means that it remains

hot for a certain time after it is turned o.

■ In the event that the food inside the appliance catches on re, immediately turn it o and

disconnect it from the power socket. Wait until the smoke coming out of the ventilation

openings disappears before sliding out the pan.

■ Do not pour icy cold water into the hot pan.

■ Always turn o the appliance and disconnect it from the power socket when leaving it without

supervision or when not using it and before moving or cleaning it. Allow the appliance to cool

down before moving or cleaning it.

■ Do not submerge the appliance in water or in any other liquid.

■ Do not place heavy items on the power cord. Make sure that the power cord does not hang over

the edge of a table or that it is not touching a hot surface.

■ Disconnect the appliance from the power socket by gently pulling the plug of the power cord,

and not the power cord itself. Otherwise, this could damage the power cord or the socket.

■ In the event that the power cord is damaged, it must replaced with an original power cord that is

available at an authorised service centre. It is forbidden to use the appliance if it has a damaged

power cord.

■ To avoid the danger of injury by electrical shock, do not repair the appliance yourself or make

any adjustments to it. Have all repairs performed at an authorised service centre. By tampering

with the appliance, you risk voiding your legal rights arising from unsatisfactory performance or

quality warranty.

SHORT CORD INSTRUCTIONS

A short power supply cord is provided to reduce the hazards resulting from becoming entangled in,

or tripping over a longer cord. Extension cords may be used if care is exercised in their use.

• Theelectricalratingoftheextensioncordshouldbeatleastthatoftheappliance.Iftheelectrical

rating of the extension cord is too low, it could overheat and burn.

• Theresultingextendedcordshouldbearrangedsothatitwillnotdrapeoverthecountertopor

tabletop where it can be pulled on by children or tripped over.

Philco PHAF 5000 - Page 4