43
Meridian 3
6. Click icon. After display “Chip erase OK.”, “Programming Success”, “ISP OFF”, it means F/W updated
OK, it will show as the follow picture:
12.4 Check the firmware version:
1. Press and buttons at the same time, power on the monitor, and then press the menu again; the
picture will appear on the top left corner. Choose “Input” item, and then choose “Factory”, you will enter into the
factory mode.
2. If the firmware version is the same as the version that you have loaded, it means the ISP writing successful.
3. AC on/off to exit the factory mode.
To Next Page
Loading...
