!
94
Meridian 3
MECHANICAL CHARACTERISTICS
Cosmetic -
Philips ID
Mechanical data files -
ProE files required
Location of Philips logo -
Per Philips make-up sheet
Gap between panel and front bezel
15"~19": <0.8mm, 19"W:<1.0mm, 20W~23"W: <1.2mm, 24"W: <1.4mm
Location of Control icons -
Location of Control icons -
Per Philips Graphic sheet
Color for resin/paint -
Per Philips make-up sheet
Fire enclosure request
Shielding Cover should fulfill international standard
Resins
x RoHS required
x WEEE required.
x Resin type/selection refer to Project Book Section 7.2 Plastic material.
If paint is used
x RoHS required
x WEEE require
x If new painting type need to implement, refer to UN-D 1235.
Plastic mold tooling
x Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
x Painting to cover up cosmetic defects due to molding is strongly discouraged.
x China RoHS mark requested.
Plastics flammability
x All Plastics to be Flame Retardant UL 94-HB or Better.
x Base / Pedestal to be Flame Retardant UL 94-HB.
x All major plastic parts (bezel, back cover) need to be molded from same resin.
x Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
To Next Page
Loading...
