Alignments
EN 23TPM8.2E LA 6.
2011-Jun-01
Also the virgin bit (MENU > Setup > TV settings > Reinstall TV
> Start now) is to be set. To set all this, you can use the
ComPair tool or use the “NVM editor” and “Service Data” items
in SAM (do not forget to “store”).
After a repaired SSB has been mounted in the set (set repair
on
board level), the type number (CTN) and production code of
the TV has to be set according to the type plate of the set. For
this, you can use the NVM editor in SAM. The loading of the
CTN and production code can also be done via ComPair
(Model number programming).
In case of a display replacement, reset the “Operation hours
disp
lay” to “0”, or to the operation hours of the replacement
display.
To Next Page