6
XD3010/61
• The panel can be removed by clicking hooks
using a screwdriver. Works the same as with the
predecessor.
Disassembly- and Reassembly advice
• To re-assemble the Top housing: make sure
that the sealing rim does not come below the
Top housing, it should be placed after the Top
housing is placed.
• Remove Cordwinder Lever.
• Remove Cordoutlet.
• Disconnect the 2 connectors from the PCB and
remove Cordwinder assy (26). (see picture)
• To remove the Motor housing:
Remove the 4 screws (E), for 2 of the screws an
extra long screwdriver is needed. (see picture)
E
E
E
E
To Next Page
Loading...
