Studio 32/39HFL2808D/12 Page | 18
Image persistence – ghosting
Please note that ghosting may occur while displaying
a persistent image (still or paused image). LED TV’s
image persistence may disappear after a short time.
Try turning off the TV for a while. To avoid this, do
not leave the screen in still picture mode for
extended periods.
No power
If your TV has no power, please check the power
cord plug is connect to the mains power socket.
Poor picture
1. Have you selected the correct TV
system?
2. Is your TV or house aerial located too
close to non-earthed audio
equipment or neon lights, etc.?
3. Mountains or high buildings can cause
double pictures or ghost images.
Sometimes you can improve the
picture quality by changing the
direction of the aerial. Is the picture
or teletext unrecognisable?
4. Check if you have entered the correct
frequency.
5. Please retune the channels.
6. The picture quality may degrade
when two devices are connected to
the TV at the same time. In such a
case, disconnect one of the devices.
No picture
1. No Picture means that your TV is not
receiving a transmission. Have you
selected the correct button on the
remote control? Try once more. Also
make sure the correct input source
has been selected.
2. Is the antenna connected properly?
3. Are the plugs connected tightly to the
antenna socket?
4. Is the antenna cable damaged?
5. Are suitable plugs used to connect
the antenna?
6. If you are in doubt, consult your
dealer.
No sound
1. Has the TV been set to mute? To
cancel mute, press button, or
increase the volume level.
2. Sound is coming from only one
speaker. Is the balance set to one
extreme? See Sound Menu section.
Remote control - does not operate
Your TV no longer responds to the remote control.
The batteries may be exhausted, if so you can still
use the control buttons on the TV. (* Is only possible
if they are not blocked by parental control and if they
are available with your model.)
Input sources - cannot be selected
1. If you cannot select an input source, it
is possible that no device is
connected.
2. Check the AV cables and connections
if you have tried to connect a device.
To Next Page
Loading...
