Studio 32/39HFL2808D/12 Page | 7
1.
Up direction
2. Down direction
3. Program switch
Program switch can control:
Volume/ AV / Standby-On
Note:
You can move the switch, upward or downward to change
the volume. If you want to change channels, press the
middle of the switch once (Position 3) and then move
upward or downward. If you press the middle of the
switch once more, source OSD will be displayed. If you
press the middle of the switch and hold about a few
seconds, the TV will switch to standby mode. Main menu
OSD cannot be displayed via control buttons.
Operation with the Remote Control
Press “MENU” button on your remote control
to display main menu screen. Use Left or Right
button to select a menu tab and press
OK to
enter. Use Left / Right / Up / Down to select
or set an item. Press “MENU” or “RETURN”
button to quit a menu screen.
Once you have connected external systems to
your TV, you can switch to different input
sources. Press SOURCE button on your
remote control consecutively to select the
different sources.
You can change the channel and adjust the
volume by using the +/- and P/CH +/- buttons
on the remote.
Installing the Batteries to the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to match
the + and - ends of the batteries in the battery
compartment (observe the correct polarity). Replace
the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
To Next Page
Loading...
